Amplified GPS Antenna Splitter | 2 Outputs, 1 Input, BNC Connectors 53050(12V) RG-58C coaxial cable

RG-58C coaxial cable

a control signal is sent from the audio panel to the AV-590 to switch the AV-590 to the selected radio therefore isolating the remaining radio from the AV-590 electric switch

This TA202 (EDMO# 6430202-9) has a USB-A connector in the front

This tape is impregnated with a specially formulated synthetic elastomer finish to improve knot holding and tying characteristics

38-inch (34mm)

Amplified GPS Antenna Splitter | 2 Outputs, 1 Input, BNC Connectors 53050(12V) RG-58C coaxial cableThe ALDCBS1X2 GPS amplified splitter has one input and two outputs and is based on the Wilkinson splitter design. The frequency response covers the entire L band (GNSS) frequencies with excellent gain flatness. In normal configuration, the RF output (J1) passes DC from a connected GPS receiver through the splitter and onto the antenna allowing the GPS receiver to power both the antenna and the splitters internal amplifier. The other RF output (J2) is